Commercial, Commercial Structural Certifications
& Environmental Testing
Spring Hill, FL 34609 (Hernando Co.)
(352) 556-7187

The Roof
back to Building Management and Diagnostics

 
Every roof has problems now and again with waterproofing, construction, and wear. Roofs have two main parts, the deck, which supports the roof structure, and the weather-resistant covering. Both of these parts need to be thoroughly inspected from both the interior and exterior to keep quality at a particular level. While construction is normally of good quality, a roof is a perishable item which needs to be replaced periodically for good performance. 
  • Pitched Roofs
    Oftentimes, pitched roofs have damage which is difficult to recognize, but can lead to structural problems. Sagging roof sections can lead to leaks and deck damage due to high moisture. Sagging roof beams can indicate structural failure, and be much more expensive to repair. Damage caused by falling tree limbs is oftentimes also unrecognized. Cathedral ceilings often lack proper ventilation, which leads to moisture buildup in wooden structures.
  • Shingles
    Unlike what most people think, roofing shingles are not intended to be waterproof, but instead, to shed water down a series of overlapping shingles, and thus, keep water out of the building structure. As such, any water which gets underneath a shingle will enter the building through the roof, and may cause damage to both the structure and whatever is stored inside. Shingles can be made of many different materials, including asphalt, mineral fiber, slate, and wood.  Clay tiles are also popular on southern homes.
  • Flat Roofs
    In order to protect a structure from the elements, flat roofs must be both completely watertight, and well ventilated. Moisture buildup is often a problem, as water takes a far longer time to leave a flat roof than a pitched roof.  Roofs should not hold ponded water, as it is unsanitary, and can damage the roof covering. Instead, proper provisions should be made for correct drainage, through either the perimeter, or the center of the roof.
  • Built-Up-Roof
    This roof type consists of several rolls of asphalt sandwiched between several layers of roofing felt and covered with a mineral aggregate, like gravel, slag, or crushed rock. Roofing of this kind is difficult to inspect, as very little damage is readily apparent to the naked eye. Structural damage is common because the asphalt and roofing felt are susceptible to damage caused by the sun's ultraviolet rays.

back to Building Management and Diagnostics